Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices

Degarege Anteneh; Birhanu Alene

doi:doi:10.11648/j.jeee.20200801.15

| Peer-Reviewed

Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices

Degarege Anteneh, Birhanu Alene

Published in Journal of Electrical and Electronic Engineering (Volume 8, Issue 1)

Received: 2 August 2019 Accepted: 12 November 2019 Published: 2 March 2020

Views: Downloads:

Download PDF

Share This Article

Twitter
Linked In
Facebook

Abstract

Design and optimized of solar PV system is a leading trend in modern energy management of distribution system. In modern or currently most of the life, customers take in energy from different sources like, sunlight, wind, diesel, biomass, even batteries and from main grid of electric power and facilitate not only its conversion into electric energy, but also the demand management, storage and generation association with the system’s output. In recently distributions generations (micro grid) implementations combine loads with sources, allow for intentional islanding and try to use the available waste heat. These solutions rely on complex communication and control, and are dependent on key components and require extensive site engineering. This paper focuses on the design, optimization and simulation of 48-V rated stand-alone solar PV using HOMER software that is suppling primarily by photovoltaic (PV) panels and using battery and diesel for comparison, but which also has the capability to tie in to a main electrical grid. A system of this size should be able to supply power for KIOT administration office buildings. The most important objectives of this paper are the selections of an appropriate PV array, the selection or design of a charge controller and the design of the system’s renewable energy converter.

Published in	Journal of Electrical and Electronic Engineering (Volume 8, Issue 1)
DOI	10.11648/j.jeee.20200801.15
Page(s)	27-35
Creative Commons	This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.
Copyright	Copyright © The Author(s), 2020. Published by Science Publishing Group

Keywords

Design of PV, HOMER, Charge Controller, Battery Sizing, Feasibility Study, Inverter

References

[1]	Bimrew Tamirat, Comparative Analysis of Feasibility of Solar PV, Wind and Micro Hydro power Generation for Rural Electrification in the Selected Sites of Ethiopia.
[2]	N. Razak, M. Othman, “Optimal sizing and operational strategy of hybrid renewable energy system using HOMER”, IEEE transaction, pp. 495 – 501, June 2010.
[3]	A. T. D. Perera, R. A. Attalage, K. K. C. K. Perera and V. P. C. Dassanayake, “Designing standalone hybrid energy systems minimizing initial investment, life cycle cost and pollutant emission”, Energy, 2013.
[4]	S. M. Hakimi and S. M. Moghaddas-Tafreshi, “Optimal sizing of a stand-alone hybrid power system via particle swarm optimization for Kahnouj area in south-east of Iran”, Renewable Energy.
[5]	G. Bekele and G. Tadesse, “Feasibility study of small Hydro/PV/Wind hybrid system for off-grid rural electrification in Ethiopia”, Applied Energy, 2011.
[6]	Farret, F. A. and Simoes, M. G. (2006) Integration of Alternative Energy Sources of Energy. John Wiley & Sons, Hoboken.
[7]	DOE’s Office of Energy Efficiency and Renewable Energy (2004) Solar Energy Technologies Program Multi-Year Technical Plan 2003-2007.
[8]	Keyhani, A., Marwal, M. N. and Dai, M. (2010) Integration of Green and Renewable Energy in Electric Power Systems. John Wiley and Sons, Hoboken.
[9]	http://rredc.nrel.gov/solar
[10]	H. Bai, C. Mai, “The impact of bidirectional DC-DC converter on the inverter operation and battery current in hybrid electric vehicles”, Power Electronics and ECCE Asia (ICPE & ECCE), 2011 IEEE 8th International Conference on May 2011.
[11]	Steeby, Donald L. Alternative Energy: Sources and Systems. The Green Destination Series. Clifton Park NY, USA: Delmar Cengage Learning. 1^th Edition; 2012.
[12]	Hart, Daniel W. Introduction to Power Electronics. Prentice Hall. 1st Edition; 1996.
[13]	Morra, James. “Multi-Input Power Converter Will Upgrade Renewable Energy Networks.” Electronic Design. Online. Published 10 June 2015.
[14]	PV Battery: Photovoltaic System Component. Solar Direct 2018.
[15]	Rashid, Muhammad H. Power Electronics: Circuits, Devices, and Applications. Upper Saddle River NJ, USA: Pearson Educational Press. 4th Edition; 2014.
[16]	F. A. Farret and M. G. Simões, Integration of alternative sources of energy, John Wiley & Sons, New Jersey (2006).

Cite This Article

Plain Text BibTeX RIS

APA Style

Degarege Anteneh, Birhanu Alene. (2020). Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices. Journal of Electrical and Electronic Engineering, 8(1), 27-35. https://doi.org/10.11648/j.jeee.20200801.15

Copy | Download

ACS Style

Degarege Anteneh; Birhanu Alene. Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices. J. Electr. Electron. Eng. 2020, 8(1), 27-35. doi: 10.11648/j.jeee.20200801.15

Copy | Download

AMA Style

Degarege Anteneh, Birhanu Alene. Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices. J Electr Electron Eng. 2020;8(1):27-35. doi: 10.11648/j.jeee.20200801.15

Copy | Download

@article{10.11648/j.jeee.20200801.15,
  author = {Degarege Anteneh and Birhanu Alene},
  title = {Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices},
  journal = {Journal of Electrical and Electronic Engineering},
  volume = {8},
  number = {1},
  pages = {27-35},
  doi = {10.11648/j.jeee.20200801.15},
  url = {https://doi.org/10.11648/j.jeee.20200801.15},
  eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.jeee.20200801.15},
  abstract = {Design and optimized of solar PV system is a leading trend in modern energy management of distribution system. In modern or currently most of the life, customers take in energy from different sources like, sunlight, wind, diesel, biomass, even batteries and from main grid of electric power and facilitate not only its conversion into electric energy, but also the demand management, storage and generation association with the system’s output. In recently distributions generations (micro grid) implementations combine loads with sources, allow for intentional islanding and try to use the available waste heat. These solutions rely on complex communication and control, and are dependent on key components and require extensive site engineering. This paper focuses on the design, optimization and simulation of 48-V rated stand-alone solar PV using HOMER software that is suppling primarily by photovoltaic (PV) panels and using battery and diesel for comparison, but which also has the capability to tie in to a main electrical grid. A system of this size should be able to supply power for KIOT administration office buildings. The most important objectives of this paper are the selections of an appropriate PV array, the selection or design of a charge controller and the design of the system’s renewable energy converter.},
 year = {2020}
}

Copy | Download

TY  - JOUR
T1  - Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices
AU  - Degarege Anteneh
AU  - Birhanu Alene
Y1  - 2020/03/02
PY  - 2020
N1  - https://doi.org/10.11648/j.jeee.20200801.15
DO  - 10.11648/j.jeee.20200801.15
T2  - Journal of Electrical and Electronic Engineering
JF  - Journal of Electrical and Electronic Engineering
JO  - Journal of Electrical and Electronic Engineering
SP  - 27
EP  - 35
PB  - Science Publishing Group
SN  - 2329-1605
UR  - https://doi.org/10.11648/j.jeee.20200801.15
AB  - Design and optimized of solar PV system is a leading trend in modern energy management of distribution system. In modern or currently most of the life, customers take in energy from different sources like, sunlight, wind, diesel, biomass, even batteries and from main grid of electric power and facilitate not only its conversion into electric energy, but also the demand management, storage and generation association with the system’s output. In recently distributions generations (micro grid) implementations combine loads with sources, allow for intentional islanding and try to use the available waste heat. These solutions rely on complex communication and control, and are dependent on key components and require extensive site engineering. This paper focuses on the design, optimization and simulation of 48-V rated stand-alone solar PV using HOMER software that is suppling primarily by photovoltaic (PV) panels and using battery and diesel for comparison, but which also has the capability to tie in to a main electrical grid. A system of this size should be able to supply power for KIOT administration office buildings. The most important objectives of this paper are the selections of an appropriate PV array, the selection or design of a charge controller and the design of the system’s renewable energy converter.
VL  - 8
IS  - 1
ER  -

Copy | Download

Author Information

Degarege Anteneh

Department of Electrical & Computer Engineering, Debre Berhan University, Debre Berhan, Ethiopia
Birhanu Alene

Department of Electrical & Computer Engineering, Debre Berhan University, Debre Berhan, Ethiopia

Download PDF

Sections

Plain Text BibTeX RIS

APA Style

Degarege Anteneh, Birhanu Alene. (2020). Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices. Journal of Electrical and Electronic Engineering, 8(1), 27-35. https://doi.org/10.11648/j.jeee.20200801.15

Copy | Download

ACS Style

Degarege Anteneh; Birhanu Alene. Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices. J. Electr. Electron. Eng. 2020, 8(1), 27-35. doi: 10.11648/j.jeee.20200801.15

Copy | Download

AMA Style

Degarege Anteneh, Birhanu Alene. Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices. J Electr Electron Eng. 2020;8(1):27-35. doi: 10.11648/j.jeee.20200801.15

Copy | Download

@article{10.11648/j.jeee.20200801.15,
  author = {Degarege Anteneh and Birhanu Alene},
  title = {Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices},
  journal = {Journal of Electrical and Electronic Engineering},
  volume = {8},
  number = {1},
  pages = {27-35},
  doi = {10.11648/j.jeee.20200801.15},
  url = {https://doi.org/10.11648/j.jeee.20200801.15},
  eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.jeee.20200801.15},
  abstract = {Design and optimized of solar PV system is a leading trend in modern energy management of distribution system. In modern or currently most of the life, customers take in energy from different sources like, sunlight, wind, diesel, biomass, even batteries and from main grid of electric power and facilitate not only its conversion into electric energy, but also the demand management, storage and generation association with the system’s output. In recently distributions generations (micro grid) implementations combine loads with sources, allow for intentional islanding and try to use the available waste heat. These solutions rely on complex communication and control, and are dependent on key components and require extensive site engineering. This paper focuses on the design, optimization and simulation of 48-V rated stand-alone solar PV using HOMER software that is suppling primarily by photovoltaic (PV) panels and using battery and diesel for comparison, but which also has the capability to tie in to a main electrical grid. A system of this size should be able to supply power for KIOT administration office buildings. The most important objectives of this paper are the selections of an appropriate PV array, the selection or design of a charge controller and the design of the system’s renewable energy converter.},
 year = {2020}
}

Copy | Download

TY  - JOUR
T1  - Design and Optimized of Solar PV System a Case Study of KIOT Administration Offices
AU  - Degarege Anteneh
AU  - Birhanu Alene
Y1  - 2020/03/02
PY  - 2020
N1  - https://doi.org/10.11648/j.jeee.20200801.15
DO  - 10.11648/j.jeee.20200801.15
T2  - Journal of Electrical and Electronic Engineering
JF  - Journal of Electrical and Electronic Engineering
JO  - Journal of Electrical and Electronic Engineering
SP  - 27
EP  - 35
PB  - Science Publishing Group
SN  - 2329-1605
UR  - https://doi.org/10.11648/j.jeee.20200801.15
AB  - Design and optimized of solar PV system is a leading trend in modern energy management of distribution system. In modern or currently most of the life, customers take in energy from different sources like, sunlight, wind, diesel, biomass, even batteries and from main grid of electric power and facilitate not only its conversion into electric energy, but also the demand management, storage and generation association with the system’s output. In recently distributions generations (micro grid) implementations combine loads with sources, allow for intentional islanding and try to use the available waste heat. These solutions rely on complex communication and control, and are dependent on key components and require extensive site engineering. This paper focuses on the design, optimization and simulation of 48-V rated stand-alone solar PV using HOMER software that is suppling primarily by photovoltaic (PV) panels and using battery and diesel for comparison, but which also has the capability to tie in to a main electrical grid. A system of this size should be able to supply power for KIOT administration office buildings. The most important objectives of this paper are the selections of an appropriate PV array, the selection or design of a charge controller and the design of the system’s renewable energy converter.
VL  - 8
IS  - 1
ER  -

Copy | Download